The simple 6-Channel 2.4GHz Transmitter has a knob and switch for both Channels 5 and 6. This allows you to set a motor speed or servo position, then switch it on to that preset position.
The right stick has spring return on both axes, the left stick has a ratchet for the up/down axis. If you prefer both axes to be spring-return, we have developed a custom Spring-Return Kit
for these transmitters.
This radio is legal for all RFL Robot Combat events! Upon loss of transmitter signal, the receiver outputs all hold in "off" state. Most new motor controllers (like our tinyESCs
) interpret this as motor-off and therefore pass the failsafe requirements. Servos will hold their last position, so make sure that does not pose a hazard in some way.
This transmitter has three programmable mixes, endpoint adjustment, subtrims, servo reverse, dual rates, and throttle curves!
*Requires an T6RA V2 receiver
(V1 will not work)
*Same transmitter as HobbyKing HK-T6A, works with HK-T6RA V2 receivers.
*Comes with Mixing on Channel 1 & 2 for single-stick robot drive applications.
*You will need a PC Cable
for reprogramming channel variables and mixing.
(Download the T6 Manual
*Installation and programming instructions have been moved to the PC Cable
Includes a free FingerTech lanyard for holding the transmitter!