The Flysky "FS-i4X" is an affordable 4-Channel 2.4GHz Transmitter with the ability to switch between AFHDS and AFHDS2, allowing it to control every robot that uses the inexpensive TR6A receiver, plus the new Malenki and Catalyst all-in-one packages!
Specifications:
- Protocols: AFHDS / AFHDS2 frequency hopping protocols.
- Front switches: Channel Mixing and Channel Reversing switches are available right on the front for ease of use!
- Sticks: Right stick has spring return on both axes (for mixed drive), Left stick has a ratchet for the up/down axis (for weapon). If you prefer skid-steer drive, you can open the case and move the spring from the left/right to the up/down axis.
- Failsafe: This radio is legal for all SPARC Robot Combat events when paired with one of our recommended receivers. Upon loss of transmitter signal, the receiver holds all channels in the "off" state. Good motor controllers (like our tinyESCs) interpret this as motor-off and therefore pass the failsafe requirements. Servos will hold their last position, so make sure that does not pose a hazard in some way.
- For users who enjoy customization, the system supports expansion to up to 10 channels through DIY upgrades.
Includes:
- FingerTech lanyard for holding the transmitter
- Requires 4x AA batteries
Works with:
- T6RA V2(AFHDS) Receiver
- Malenki all-in-one AFHDS2 receiver+ESCs
- Catalyst all-in-one AFHDS2 receiver+ESCs
* You may bind multiple receivers to one transmitter. That means you can have multiple robots with receivers in them, and just one transmitter to control them. Make sure to set up all the robots the same so that you don't need to reprogram the transmitter between matches!
Switching between AFHDS and AFHDS2:
- Comes set for AFHDS to match the included receiver. To switch to AFHDS2, hold both sticks in the bottom left position while turning on the transmitter. It will beep twice then continue to beep until power-cycled. Do the same to switch back to AFHDS again, and it will beep just once.
Shopping cart
Login Status
