- 40A Brushless Speed Controller programmed for both Forward and Reverse directions.
- These ESCs operate on new AM32 programming, with our own customized firmware that provides amazing low-end control and torque compared to BLHeli!
- Use it to control our Mega Spark Brushless Drive Motors or a S2838 or F4006 weapon motor for reversible weapon direction!
- Single-direction version available here: BL40A-AM32
Specifications:
Operates on FingerTech's optimized AM32 firmware, programmed for reversible direction
Voltage: 11.1V - 22.2V (3S-6S lipoly)
Current: 40A continuous, 45A burst (<10 seconds)
Size: 37 x 12.4 x 6.5mm (1.5 x 0.49 x 0.26in).
Weight: 12.1grams (0.43oz)
Motor wires: 3.5mm female bullet connectors, 8cm (3.15in) wire length.
Note:
- No on-board BEC. Must provide 5V to radio receiver via other ESCs or separate dedicated BEC.
- Wiring: Connect the three motor wires any way you like. If the motor is spinning backwards, swap any two wires.