2-Pin JST Connectors (Male)

High quality, high strand count silicon wire gives higher current throughput than standard wire of the same diameter. Connectors are plated for higher current handling.
Good for a power disconnect in a low current system, or as a general connector in smaller bots.

Specifications:
Wires are 20 gauge, 10cm (4in) long.
Current: Rated 8A continuous (Though combat robots routinely run >60A through these with no problem!)
Male Connector Housing Dimensions: 13 x 7 x 3mm (0.51 x 0.28 x 0.12in)
Female Connector Housing Dimensions: 20 x 6 x 3mm (0.78 x 0.24 x 0.12in)
Connected Dimensions: 24 x 7 x 4mm (0.94 x 0.28 x 0.16in)

Tip: Female connector conventionally used for robot-side (non-live side) of connection.  Male connector is used for battery or power source.