• FingerTech's Mecanum Wheels allow any robotics enthusiast to add omni-directional capabilities to their creation.

• Competition Grade set includes upgraded aluminum mounts and threaded pins with screws to hold the rollers on. No gluing is required. Adding some Loctite to the screws will reassure you that an improperly glued roller will not fall off during a competition.

• Precision engineered delrin hubs and rubber rollers attach to a customizable mount for any motor shaft size between 3mm and 1/4".

• Set includes four competition-grade wheels (two "A" side and two "B" side), hex wrenchs, and instructions for installing the wheels.

• FingerTech's revolutionary new Mecanum Wheels allow any robotics enthusiast to add omni-directional capabilities to their creation.

• Hobby Grade set comes with plastic motor mounts and plain steel pins. Gluing the rollers onto pins is fine for hobby use. For additional reliability, check out the Competition Grade set.

• Precision engineered delrin hubs and rubber rollers attach to a customizable mount for any motor shaft size between 3mm and 1/4".

• Set includes four hobby-grade wheels (two "A" side and two "B" side), hex wrench, and instructions for installing the wheels.

• Need every ounce of performance from your Mecanum Wheels?  This upgrade will put you at the top of the class!

• Delrin is a very low friction material, but it can't compare to actual bearings.  Installing roller bearings in your Mecanum Wheels improves the sideways translation from 75-80% (original) up to 85-100%!

• Installation only requires drilling the plastic hub's roller holes to 1/4" and pressing in each bearing.

• Includes 24pcs needle roller bearings - 3.175mm ID x 6.35mm OD x 6.35mm wide (1/8" ID x 1/4" OD x 1/4" wide).

• Update your existing Hobby Grade Mecanum Wheels to Competition Grade Mecanum Wheels!

• Parts are included for upgrading a full set of four wheels.

• Single "A-side" or "B-side" Mecanum Wheel
• See Mecanum Set - Competition Grade or Mecanum Set - Hobby Grade for a full description.
• Setscrew for both CG and HG requires 0.050" hex wrench 
• CG cap screws require 1/16" hex wrench 

• If you will be mounting your Mecanum Wheels on different robots or replace the motors and need a different shaft bore size, you will want to pick up some extra mounts.

• Bore is 3mm, can be drilled out to accommodate up to 1/4" shafts.
• Includes 6-32 setscrew
• Now available in aluminum or delrin.

• Low-Bounce, Non-Treaded Foam Tire
• 5/32" (3.97mm) fits Lite Hubs, or can be drilled up to 3/16" for other shaft sizes.
• Diameters from 1.75" - 3.0"
 

• Lite Hubs press into Lite Flite and Lectra Lite wheels, providing a secure and very lightweight method of mounting a wheel onto a motor shaft.
• Mount wheels onto any 3mm shaft  (Can be drilled out for 1/8" motor shafts)
• A setscrew secures the hub to the shaft.  Don't ever glue your wheels to your motors again!

• Similar to Lite Flites but not as wide.
• 1/8" (3.18mm) bores can be drilled out to 5/32" for installing Lite Hubs.
• Diameters from 1.50" - 2.25"
 

• Softens and increases the natural adhesion of foam tires for maximum traction.
• 4 oz. bottle

• A sticky solid rubber tire on a machined one-piece aluminum hub.

• Drill and tap straight through the tire and hub to have a setscrew lock onto a drive shaft.
• Axle holes may be drilled out to accommodate larger axles.