Don't like "tank" steering? Need a stick free for weapon control?
The Channel Mixer combines the "left/right" (Rudder or Aileron) and "up/down" (Throttle or Elevator) channels of a single stick into two individual motor outputs.
This allows you to maneuver the robot with just one thumb, leaving the other open for weapon control.

Dimensions: 31 x 10 x 9mm (1.22 x 0.39 x 0.35in)
Servo wire length: 20cm (7.9in)
Weight: 5grams (0.18oz)
Mixing Rate: 1x1 Fixed
Precision: 200 steps

To hook up your robot; plug the bottom servo lead into Channel 1 of your receiver. Plug the top lead into Channel 2. Plug your Right motor's speed controller into the top slot of the mixer. Plug the Left motor's speed controller into the bottom slot. This will set up your robot to drive off the right transmitter stick.

The mixer is labeled "S+-" to ensure the speed controllers are not connected incorrectly.